Hi I am thinking about replacing the complete pad from another unit. I measured it at 201.5mm squared, and it just happens that I have a Excalibur Kingmaster 3. Its pad will fit if cut down. (202.5mm one millimeter over size when cut down to best fit, I will split the 0.5 mm) Of course I am not going to destroy the Excalibur Kingmaster 3, I am going to try to get a new Pad. Besides, no way you will pull off an already used Pad and hope that the pad will be in one piece. They are glued on.

Has anyone attempted such a task. I think its possible, these sensor boards are nothing more then buttons that make contact with the circut board. But I have never pulled one off.

Anyone attempted this before.

Thanks
Steve how.