Dear Mike,
Zitat von
Mike
I cannot get a Type 2 board or the pieces to work with a Type 1, or vice versa.
Correct, these are two different technical solutions - you connot mix them!
Zitat von
Mike
To my surprise my v2.2 eproms (bought with a Tasc in 1994) do not work with the two SB30s which use Piece Type 1. The R30 comes up the correct version information but does not react correctly with the SB30 when v2.2 is installed. There is no problem using v2.2 with the SB30 which uses Piece Type 2.
Does anybody know if v2.2 only works with the earlier Smartboards/R30s?
I will test this, I am not sure about it - this seems to be logical; piece type 1 is the recent technology and v2.2 is the older software version - apparently v2.5 and piece type 1 appeared on the market at the same time. Possibly there are different v2.2 versions?
Regards, Michael