Good morning!

After many years I bought the iconic Mephisto III. I would like to clean it because the case and buttons are very dusty, as is the display window (from the outside).

Does anyone know how I can take the unit apart (remove the casing) - I don't see screws anywhere, so I assume the whole thing rests on snaps?

Of course I know I will lose my warranty by doing this

Thank you in advance for your help!
larryadler

Es gibt vier Schrauben an der Unterseite, die durch Kunststoffnoppen abgedeckt sind. Unter dem Modul neben der elektrischen Leiste ist Mittig noch eine Schraube.

There are four screws on the bottom covered by plastic knobs. There is another screw in the middle under the module next to the electrical strip.


Übersetzt mit Google Übersetzer
Translated with Google translator

Mephisto Brikett Schraubenanordnung

Miniaturansicht angehängter Grafiken

 

Thank you for your reply! I have to admit that things are probably different on my device. I have a plastic spout in place of the screws at the corners (it looks from a distance like a black screw, but is not). I also don't have a screw at the module socket. I am attaching pictures.

The first units had no screw in the middle ... and you have to remove the black plasic caps ... below are the screws ...

__________________
This post may not be reproduced without prior written permission.
Copyright (c) 1967-2024. All rights reserved to make me feel special. :-)

Das ist noch eines der ersten Grundgeräte, solche Batteriefedern hatte mein erster Mephisto auch. Womöglich läuft dieses Gerät auch nicht mit 6,1 Mhz. Eine Garantie wird es aber kaum noch darauf geben .

Wie auch immer, viel Spaß mit dem Mephisto III.

This is one of the first basic devices, my first Mephisto also had such battery springs. This device may also not run at 6.1 Mhz. But there will hardly be a guarantee anymore.

Anyway, have fun with the Mephisto III.

Everything works as you specified thank you for your help, topic to be closed.