Sadly I do not have another modular board to try.

These 2 points on the board have a hairline connection. Do they have to be connected nor not in your experience?



Eprom corruption is possible because when I first opened the module, one side of the Eprom was slightly raised but of course I had already tried to run it.

If any member in the forum is willing to help me with a
pre programmed eprom, I will gladly pay for it.

If I purchase a new 65C02 from ebay, does it matter
if the speed is higher then 3MHz or try to get the same speed.

Thanks again everyone.

Murat