Zitat von
GONeill
I have the Certabo Raspberry module and use the image that Pietro sent to me to connect to my Certabo and Tabutronic boards. I'll check with Pietro that I'm using the correct image.
My driver does require a Microsoft library to be loaded for BLE support, but I think you have other boards that you use with BLE and my drivers, so I don't think that is the problem. Does my ComPort program see the board in the "BLE" tab? It's odd that the four lights go out and yet it then says the connection failed. I suppose you see the message "Connecting (please wait)" on my screen before the connection failed message?
Hi Graham,
as you guessed the drivers are installed for the other boards and the COMPort App detects the BLE device as "Certabo".
And yes, the screen shows "Connecting (please wait)".
Don´t know if this helps:
usually if I disconnect a board e.g. running Fritz, the four lights go on instantly. Now if I disconnect after the unsuccessfull connection, the lights stay off and go on only when I close the Fritz program. A little bit curious.